Product characteristics of DC micro water pump

Jun 12, 2025 Leave a message

1. Long lifespan, no maintenance required, small size, high efficiency, low power consumption, strong anti-interference ability, and smooth operation.
2. Carbon brush free, pollution-free, electronic commutation, long lifespan.
3. The stator and circuit board of the motor are sealed with epoxy resin and completely isolated from the rotor, solving the leakage problem caused by long-term diving of the motor type DC water pump. It can be installed underwater and completely waterproof.
4. The parameters of the water pump can be modulated. The 24V water pump can modulate a 2-meter head or a 7-meter head, with the same volume, and can operate with a wide voltage range.
5. The water pump shaft adopts high-performance ceramic shaft (stainless steel shaft can be selected to reduce costs), with high precision and good wear resistance. Due to the precise fit of high-precision shaft sleeve and ceramic shaft (other materials can be replaced to reduce costs), the noise is low, and the noise with lower power can even reach below 30 decibels.
6. The three-phase Hall free program driven DC water pump can achieve PWM speed regulation, analog signal (0-5V) speed regulation, and potentiometer VR manual speed regulation, which can adjust the flow rate and head.
7. The three-phase DC water pump has a soft start, no impact, low starting power consumption, and the circuit board is completely separated from the pump body. There are no electronic components inside the pump body, and the pump body is made of high-temperature resistant materials. The water pump can be used for a long time at a water temperature of 100 degrees Celsius. Equipped with impeller rotor jamming protection, reverse connection protection, overload protection, and overcurrent protection.
8. The water pump interface is rich, with 4-point thread, 2-point thread, inlet and outlet 8mm, 10mm, 22mm, 27mm, etc.
9. If it is necessary to increase the head of the water pump, the water pump can be connected in series, and the head can be doubled.
10. Water and land dual-use (installed below the liquid level for external use).