1. Sliding bearings
The materials for the sliding bearings of stainless steel gear pumps include impregnated graphite, filled polytetrafluoroethylene, engineering ceramics, etc. Due to the excellent heat resistance, corrosion resistance, and friction resistance of engineering ceramics, the sliding bearings of stainless steel gear pumps are often made of engineering ceramics. Due to the brittleness and low expansion coefficient of engineering ceramics, the bearing clearance must not be too small to avoid shaft hugging accidents.
Due to the fact that the sliding bearings of stainless steel gear pumps are lubricated with the medium being conveyed, different materials should be selected to make the bearings according to different media and operating conditions.
2. Isolation sleeve
When using a metal isolation sleeve, the isolation sleeve is in a sinusoidal alternating magnetic field, inducing eddy currents on a cross-section perpendicular to the magnetic field lines and converting them into heat. The expression for eddy current is: where Pe - eddy current; K - constant; N-rated speed of the pump; T-magnetic transmission torque; F - Pressure inside the spacer; D - Inner diameter of the spacer sleeve; The resistivity of a material; The tensile strength of the material. After the pump is designed, n and T are given operating conditions, and reducing vortex can only be considered from aspects such as F and D. The use of non-metallic materials with high resistivity and strength to make isolation sleeves has a significant effect in reducing eddy currents.
3. Control of cooling lubricant flow rate
When the stainless steel gear pump is running, a small amount of liquid must be used to flush and cool the annular gap area between the inner magnetic rotor and the isolation sleeve, as well as the friction pair of the sliding bearing. The flow rate of the coolant is usually 2% -3% of the pump design flow rate, and the annular gap area between the inner magnetic rotor and the isolation sleeve generates high heat due to eddy currents. When the cooling lubricant is insufficient or the flushing hole is not smooth or blocked, it will cause the medium temperature to be higher than the working temperature of the permanent magnet, gradually causing the inner magnetic rotor to lose magnetism and the magnetic transmission to fail. When the medium is water or water-based liquid, the temperature rise in the annular gap area can be maintained at 3-5℃; When the medium is hydrocarbons or oil, the temperature rise in the annular region can be maintained at 5-8℃.
4. Permanent magnet
Permanent magnets made of rare earth permanent magnet materials have a wide working temperature range (-45-400℃), high coercivity, and good anisotropy in magnetic field direction. They do not experience demagnetization even when they are close to the same polarity, making them an excellent magnetic field source.
5. Protective measures
When the driven components of the magnetic transmission operate under overload or the rotor gets stuck, the main and driven components of the magnetic transmission will automatically slip to protect the pump. At this time, the permanent magnet on the magnetic actuator will generate eddy and magnetic losses under the action of the active rotor alternating magnetic field, causing the temperature of the permanent magnet to rise and the magnetic actuator to slip and fail.
Structural characteristics of stainless steel gear pump
Jun 15, 2025
Leave a message
